Hi, I have a PowerMax Complete wireless alarm system (D303983) and replaced the battery on one of the PIR's, a task which I have successfully completed numerous times over the years. On this occasion when I go to set the alarm, I get a message " Disarm not ready to arm, Alarm in memory" The Alarm Triangle in the front of the panel it not lit. Can anyone please advise on how I can reset this error message
Unable to arm a Visonic Powermax Alarm System
- Thread starter 802595353
- Start date
Check it’s been done correctly and do a walk test.
No reason why it should be any different unless you have done something different.
If it persists check event log for information/faults
No reason why it should be any different unless you have done something different.
If it persists check event log for information/faults
Lid on correctly, tamper switches closed.
