Wall Mounted Weight Plates On Single Layer/Skin Brick Wall

[hoodtrysdiys]

Hi, so I am assessing if my exterior garage/outbuilding can support the weight of a wall mounted weight plate storage rack (See picture two for the rack), there would be two racks both weighing at 80KG~ when plates are fully loaded at two spread-out locations as marked in red, photo 1.

The wall is a single layer/skin, with columns in the centre and at each corners as in photo 1, with wooden beams on-top supporting the roofing.

Am I worrying about nothing and the wall can take the weight or is it a bad idea?
Is there any way to reinforce the wall or maybe use stringers to attach the rack to spread the stress? Open to ideas.

Thank your for your time, I am a novice at this so any advice is welcome.

 

[foxhole]

I would fit close to brick columns , but should be fine.

 

[thomp1983]

What's on the other side of the garage wall, I'd be tempted to use bolts all the way through the brickwork with spreader plates on the back

 

[Deleted member 292770]

i’d leave them on the floor and bend to pick them up. It’s good ecsercise.

 

[Wayners]

Be fine imo.

 

[hoodtrysdiys]

Thanks for the replies/advice, ill give it a bash with decent sized bolts