- Joined
- 22 Jul 2016
- Messages
- 5,930
- Reaction score
- 1,094
- Country
i am working on a stacker trolley. This is basically a kind of manual forklift
The lift is generated by a hydraulic jack that pushes a bar (frame) upwards, and pulls a trolley upwards via two bicycle type chains
The chains are pinned into the main chassis by a pin with a tiny split-pin on each end. They are small solid round pins, about 4/5mm diameter and 10 mm Long.
Similar to a drill shank but crossdrilled for location security
Where would I source some more?
Or I could get something made and heat treated
Ta
The lift is generated by a hydraulic jack that pushes a bar (frame) upwards, and pulls a trolley upwards via two bicycle type chains
The chains are pinned into the main chassis by a pin with a tiny split-pin on each end. They are small solid round pins, about 4/5mm diameter and 10 mm Long.
Similar to a drill shank but crossdrilled for location security
Where would I source some more?
Or I could get something made and heat treated
Ta
