Hi all,
Replacing an V old wired PIR as it got damaged by workmen. (using a 9800 control !)
The old model is a Racal-Guardall, and have 8 wires connected to the 7 pins.
From what I can see and figure out,
Red +12v
Back -12V
Blue & Yellow = Alarm
Orange & Brown seem to be discarded as connected to spare
Green and white connected to Tamper.
I am tempted to replace it with a Bosch Blue Line Gen2. Will this work please? (is there another better one you would recommend?)
If so, what wires goes where please?
as this is the wiring diagram I found at Bosch
So I am guessing the power is easy,
Red +12v
Back -12V
Is the NC connector same as the ALARM? does it mater which of these wires goes on which terminal?
I am guessing this would be blue and Yellow?
And T must be TAMPER?
so Green and White, again does it matter which way round these wires are connected.
Many thanks for any help
Replacing an V old wired PIR as it got damaged by workmen. (using a 9800 control !)
The old model is a Racal-Guardall, and have 8 wires connected to the 7 pins.
From what I can see and figure out,
Red +12v
Back -12V
Blue & Yellow = Alarm
Orange & Brown seem to be discarded as connected to spare
Green and white connected to Tamper.
I am tempted to replace it with a Bosch Blue Line Gen2. Will this work please? (is there another better one you would recommend?)
If so, what wires goes where please?
as this is the wiring diagram I found at Bosch
So I am guessing the power is easy,
Red +12v
Back -12V
Is the NC connector same as the ALARM? does it mater which of these wires goes on which terminal?
I am guessing this would be blue and Yellow?
And T must be TAMPER?
so Green and White, again does it matter which way round these wires are connected.
Many thanks for any help
