chimney breast

Property: Victorian Room Kitchen / Diner Is it possible to install log burner inside a fireplace (which was sealed up in the 1970s or 80s). The chimney breast in the kitchen diner. There are wall cabinet on the chimney cabinet as well as a breakfast bar. Is is possible to keep the existing...

I’ve recently moved house and currently in the process of removing back boiler (works on wood) from fire place. I’ve had a plumber disconnect all the water. Was hoping someone could offer some advice on removing the brick work that sits on the top of the back boiler? Would this brick work be...

Hi everyone, wondering if anyone can help! I removed the gas fire and surround we had on our chimney breast and found this underneath. I know that the central brick part (the bit that looks newer/highlighted in green) was installed around 20 years ago (house is 1960s). I want to remove the...

Hi everyone, I’m new to the forum so I hope this is in the right category. I have just moved into an ex military house and it has this chimney stack right through the middle of the living room right through to the roof. I’m wanting to knock it out. Only half of the stack is for the chimney (in...

We are having a new bathroom fitted in our victorian terrace and returning the lowered ceiling to its original height. On opening up corner of the lowered ceiling to have a look, we discovered the that at some point the old chimney stack had been removed to ceiling height and left unsupported...

We had our chimney capped and repointed during the summer, however have noticed a couple of damp patches at the front and to the side. the two discoloured/ brown bits are reading high (about 37/8) but everywhere else seems fine. anyone have any idea what else could be causing it or how to...

Hi, We've had our chimney breast opening widened (probably a brick wider than the builders opening) and the lintel replaced with a stronger one and moved higher up at the front. Some of the brickwork needed to be cut out. Is our chimney flue and the second/third row of bricks supported by the...

Hello, I have a chimney breast on the ground floor of my home. The breast and stack has been removed from the first floor upwards so this is the only piece remaining. I want to angle grind a rectangle out of the breast at waist height and then put in a plywood box to create some sunken shelves...

Hi folks, Looking to have a multi fuel stove installed in the New Year but when I look up my chimney breast, I notice that it is not a straight path to the roof but that it zig zags at the beginning. Is this normal? Would I need to have this removed to fit a 5” liner? Any other things I should...

I want to ventilate a room that has had internal wall insulation applied to it, and the chimney is not ventilated. I was thinking of putting an air vent into the room (where old opening was) but they look a bit unsightly and was thinking it will allow cold air in, or will the hot air leaving...

Hey, Took the fireplace out and got left with what looks like a neat builders opening. Can this opening be extended if I add a new wider lintel? Extending only by 10cm each side. Can the gather/bricks inside be removed? What if sides of chimney breast are hollow? Seems like they might...

Hi, Looking for a bit of advice regarding chimney breast opening. We are wanting to expand the chimney breast opening by approx 10cm each side (width). This means the following: - adding acrow props + strongbow - replacing lintel with bigger one - knocking out bricks at the sides for 10cm...

Hi all, Thanks in advance for any help / advise it is all greatly appreciated. I appear to have damp in the upstairs chimney breast. The chimney has been removed from the roof and is open in the loft as is the fire place in the bedroom. This is an outside wall. I've had a roofer check the...

Hello! Recently bought my first house and I’m a total DIY novice. We had a gas fireplace removed (the kind that sits midway up the chimney breast and looks like a Tv),and had the gas capped. Our plan was to just use the recess as a feature in the chimney breast, as we do not want a new gas...

Hi Guys, Just wanting some advice on a loft chimney breast support. At this moment in time i haven't actually gone into the loft to measure it, but the breast runs down of course from the roof, loft, into bedroom 1 and the living room. The idea is to take it out of the bedroom to allow for...

Hi all! I'm opening up a fireplace, ready to accept a wood burning stove. Property is 1918. It's clear it's been chopped about over the years. At some point it seems to have had some kind of large inset fire or similar installed. I haven't been able to quite figure out what it was (any...

Hey everyone, I've just taken out the hearth in one of my first floor bedrooms and discovered two concrete slabs built into the wall. They're really solid & sturdy, but I'm not sure how far they are built into the wall. I was wondering if I could run my noggins directly off of them instead of...

Hello there, I’m wanting to add a spur to a socket that’s on a ring circuit, the socket I’m spurring off is in the skirting board and in the alcove on the right of the chimney breast. It’s on a 32a RCD. I’m after some help and ideas in the best plan of attack to route the wire as I can’t come...

Hi all, We have a Victorian terrace where we have 2 damp walls around a chimney breast that has been opened (we planned on using it for storage). We thought the bathroom behind iy was leaking but we ahave since ripped that out and can't find a culprit. When there is heavy rain, we do get some...

Hi, In the process of purchasing a LG 55CX OLED and looking to mount this on a cantilever mount. I've been recommended Sanus mounts, but none of their mounts seem to say they’re suitable for mounting on a brick wall The chimney is unused (and the alcoves either side are too small for the 55")...