dishwasher

Hi just wondered if this was normal busy painting the kitchen cupboards. I've removed the dishwasher piping but noticed when we run the tap in the sink water is coming out the dishwasher pipe, if we run the tap slow it's fine and doesn't overflow out. Is this normal as that would mean the...

Hi, I have bought an integrated Sharp slimline dishwasher and am currently trying to install it, however, the only available space I have for it is between the cooker and a wall (which has an opening of just over 450mm). The instructions say to fit 4 small metal brackets to the machine and...

Hey, I’m looking for some help trying to understand the problem with my dishwasher. I have an AEG Proclean dishwasher and last night it stopped working with error i50.I’ve looked online and found that the problem might be with the pump, that there might be something in it. So today I today I...

Hi any help on this one is appreciated: My Neff S51T69X2GB Dishwasher has started to not complete its wash cycle and i find it on 00 minutes with undrained hot water in the bottom not too long into a wash cycle (maybe 10-30 minutes in but is seems to vary). It did this once or twice before in...

Hi Everyone We had a bit of change on the original plan and haven`t had dedicate tap for the dishwasher. I`m planning to get feeding after the isolation valve under the sink but struggling to find the right vale and connector to make it work. Idea is to keep the isolation valve for the tap in...

We're desperate for a dishwasher, but our kitchen is tiny. Where could we fit one? Underneath the boiler? It wouldn't be deep enough though because of the pipes...

Dishwasher is bosch SGS4012GB/01 My dishwasher kept tripping on the end of each cycle. I assumed it would be something to do with the drain pump as it was the end of the cycle so I took all panels off and inspected wiring and water bladder. As you can see the pressure chamber was filthy and...

Hello, I have an integrated candy dishwasher, CRIN 1L380PB-80. And the P3 light is red and the reset button is red. When I press start the 3 lights on the right hand side flash and it won’t start. Does anyone know what this issue is?

Hi, I have a Neff integrated dishwasher which isn't filling with water, and hope someone can help please. The E-Nr is S511A50X0G/52. I have checked (not necessarily in this order!):- 1. Pipes to make sure they're not kinked. 2. Water inlet valve under the sink (water is flowing there) 3. The...

Hi Everyone! I have a rather old integrated dishwasher, Whirlpool ADG 7470/2. As of recently it refuses to work, showing "6 flashes" error code. Perhaps local experts could help me figure out what is going on. Here is what I know so far: (1) "6 flashes" apparently means that the dishwasher...

Hi, My dishwasher has recently started making a buzzing noise and will not move on to the second part of the wash. It also did it just before the last rinse as well the other day. If I am here and notice it I can open the door push the top tray and moves on to the next stage. I had just...

Hello all. Can you tell me what is a Air Breaker Box on a Dishwasher and what does it do please? Just bought a used Kenwood Dishwasher KDW60s16 couple of days ago . Seems to be working fine - only thing is , annoying if anything, there is a groan noise at around 45mins left of a 90min cycle...

Hello I have recently moved into a new turn-key house and they have a Candy Dishwasher CDI 1LS38S-80/T installed. I have added salt and turned it on. I have selected an Eco Wash and hit express and hit start but no matter what I hit it always activates a 3 hour delay and wont start straight...

Beko DW686 Dishwasher Our Dishwasher didn't drain so I took of the lower panel and saw a blocked pipe from the sump. I cleared the block and the dishwasher worked again for 2 or 3 washes. It then got stuck on drain again. I took the lower panel off and it had some water in it causing the...

Hi all, I've replaced a power switch on a Zanussi DW908W for someone I know, I'm certain I have it wired properly, I plugged the wires back in the same order I took them off, though the new switch is a little different than the old one-I've checked that power is coming to the switch, but it is...

Zanussi Aquasave Type. 91181-2A Ser. 60800400 Prod. 911812019 The sides and top door seal looks good and is tight on the internal stainless steel lining on closing. The door bottom rubber is not a seal, just a flap, to slow water progressing forward within the base tray. The leak runs...

Not too sure if this is the correct forum group to post this so please move if not. I have installed a dishwasher under a quartz worktop on a platform but there is still a 20mm gap between the top of the dishwasher and bottom of the worktop. Do I need to raise the platform so it sits flush...

Hi, I was wondering if anyone could please help us source a full size freestanding dishwasher with a depth of 57 or 58 cm depending on how generous the recess/overhang is at the back. The dishwasher should also be flat at the front no concave door or sticking out handles. The issue we have...

Hi, My Zanussi DWD 939 dishwasher's power button turned off. If I push it back on forcefully then the machine works but as soon as I remove the finger, it turns off. Is this button issue or some sensor gone wrong? Thanks

Hi, My Hotpoint integrated dishwasher has started beeping and flashing all it's lights whilst running. As far as I can tell it's still running during a cycle but has a pattern of beeping and flashing the lights. I've had a google to see what it could be but results only talk about 3 lights...