electric

Hi. I'm putting a new ceiling light in and wanted some advice. I've got a single core with 3 wires. Red, Black and a bare copper earth. I've purchased some sleeving to cover the earth wire after reading somewhere that I should The lighting rose has an earth wire running from the core My...

Hi, so recently my electric shower started running lukewarm at settings where it would usually run nice and hot. To get it to run hot, it has to be turned to higher settings, but with that, the water pressure drops significantly. I’ve also noticed that the half power light is no longer lit...

.

Hi! I am removing the old extractor fan in my bathroom - the old has three wires - live, switched live, and permanent live. It is hooked up to the fan isolator. my new fan only has two wire inputs. Permanent live and neutral. can I use my new fan with two of the three wires which went into...

Hi I want to put a external commando socket on an out side wall. Conveniently my consumer unit is located just at the other side of said wall. Please take a look at this picture of my downstairs toilet room, link here of it doesn't work for any reason What's would be considered the best route...

Hi all, Thought I'd pop a question on here if anyone doesn't mind sharing their expertise it would be greatly appreciated :D I'm fairly proficient at DIY but regs can get complicated with electrics, so wanted to ask first. I understand safe zones for electric cables, I was just wondering if...

Hi after some advice on what paint would be best to use to paint our outside electric /gas meter boxes which have flaked a little. House is 5 years old so the meter boxes aren't to old, I think there fibreglass? I've seen dulux weathershield satin mentioned a few times but would I need to sand...

Some more stupid questions. I'm thinking about different ideas for a bathroom remodel and I want to swap the taps to the other end of the bath and mount them and the shower on the wall. My idea is to box in the area from the top of the bath to the ceiling to put the plumbing in, because the...

Hi, Hope someone can help. I've been changing the faceplates in my bedroom and the double switch to our en suite has me stumped. It controls the light and the extractor fan however, the terminals are different. I tried wiring the brown wires to L1s (notice 1 brown wire has to parts exposed (is...

Hi everyone, was hoping for some expertise. I have no knowledge of anything in this post so please don’t laugh at me lol. Moved into a new flat (2 bed all electric no gas) and we have an economy 7 meter set up with an off peak system for the boiler and heating. I’ve never used this before and...

Hi all, We are trying to ascertain what size cable we have for our current electric shower as we are purchasing a new one and need to know what kw we can get. The current shower is 8.5kw and ideally we'd like to go a little more powerful. Can anyone tell whether the current cable is 6mm or 10mm...

I use a standalone Electric Heater just to heat the room where I'm sitting as i'm working up in the attic/loft so its cold at this time of year! However this has suddenly stopped working for some reason? I have changed the 13A fuse as a precuation but still nothing? The heater did fall over...

Hey! I moved into a new flat recently, and it is fully electric (which is new to me) and taking me some time to figure things out. I'd appreciate some guidance so I can feed back anything I need to my lettings agency. So, I have an immersion tank with 2 switches. I've been investigating and...

I am purchasing a lower-ground floor flat which currently has all of the plug sockets and wiring surface mounted in trunking. I'm undertaking a renovation project on the house soon so now is the time to get them hidden! I am looking at installing a wet UFH system between a concrete slab and my...

Hey I need some advice ive done some wall chasing to fit some back bock on an old surface patress socket But when I started from the plaster it seems that there had been some work done on thd same location, and the area was filled back again with plaster Am starting to be concerned because the...

My house just has a small electric water heater. Refitting the kitchen, I've discovered the appliances are fed from the hot supply. Which struck me as odd considering. Presumably more expensive to run that way. Now I'm wondering whether this was to maintain tap water temp when appliances are in...

Just noticed this on my Henley block between my meter and my consumer unit. Tails on left are to consumer unit, tails on right are to electricity meter. I am unsure if the tails have worked lose over time due to never being tightened up properly in the first place or this has always been like...

Hi, Can someone confirm whether the consumer unit in a garage (setting up my man cave) has to follow the "1350mm and 1450mm from floor level" rule? It is not clear to me if this would only apply to habitable area. I'm insulating the place and would like to get conduits in place for the CU. TA

My towel rail gets too hot to touch. Its electric, no water feed so i assume its water filled. Is there anyway to lower the temperature? I have provided a picture of a screw/valve? Situated on the top of the towel rail. Didnt want to touch it, but is that possibly a way to do it? Any help...

Hi So moved into a 1930s house, in the process of doing it up and trying to do as much as possible myself I've got little knowledge in general around DIY hence hitting a snag and wanting some guidance please see photos So from research I can see is that old electrics seem to only have the...