structural

Hello all I have a tiny 2 up 2 dawn mid terrace house I want to do a simple attic conversion to add a room. With just a velux window and that's it. Haw hard would this be to carry the work out myself. I want to do this as cheap as possible and want it to be done on the down low if u no what I...

Two inner concrete lintels(100x~250) supporting 1/2 of external 30s solid walls, one supports a 1.8m window opening in 1st floor (carrying 3 courses and roof) and the other a 2m window opening in ground floor (supporting 10 courses and then an exact size window opening in 1st floor), are blown...

I am looking to buy a house but on the rear on there are quite a few cracks / stair step cracks, pictures attached. I want to get a surveyor or structural engineer to check prior to proceeding but which person would be best? Do you think I should avoid the property as it will cost quite a bit...

Good evening, I'm in the process of ripping out our pantry, putting in a suspended floor and fitting an understairs toilet. I've read around a bit and looked on a few forums but can't seem to figure out what is supporting our landing, aside from possibly the door frame to the pantry below which...

Hi, Just moved into a new build with a double garage. The double garage is a nice size and I want to use it as a man cave. The roof structure is formed of a complex network of slim rafters spanning the space. Over long spans, they are joined together using those thin metal plate rafter...

Hi, I would like to lay a new floor covering in the first floor bedroom in our victorian terrace. The problem is that the 5x2 floor joists (actual size 120mm x 60mm) are at 800mm centres with no noggins and span roughly 2.4m. Ideally I would make the structure better in order to accommodate...

Hi, I would like to lay a new floor covering in the first floor bedroom in our victorian terrace. The problem is that the floor joists (120mm x 60mm) are at 800mm centres with no noggins, spanning roughly 3.4m. Ideally I would make the structure better in order to accommodate a standard 18mm...

Hi, Following my last post where I got some really helpful answers I wanted rely on you guys again! We currently have an upstairs layout as shown in the image. We are looking to knock down the wall between the WC and the bathroom to increase the size of the bathroom but wanted to check whether...

Hello, I’m just about to fit some steels on my self build extension extension and I have the following questions- Do I need to use any kind of dry pack mortar or can I bolt straight down onto the pad foundation I have laid. It’s pretty flat as I levelled and smoothed it of after pouring...

Hi all, we are in the process of getting a structural engineer to do some calculations for steel supports as we are going to be knocking out supporting walls (hopefully) Any advice on what we should be asking the structural engineer? Qualifications, insurance etc? We know what walls we would...

Hi all, not sure if I'm posting this in the right category... I want to add a small chandelier type light fitting to hang in the centre of the room. There has never been a light fitting there so there are no cables existing. It is a very old house with exposed wooden structural beams and...