wall

I have a stud going in at each end of a bath and was wondering what thickness Aquapanel on the stud would best? To tile over. What does primer (BAL etc) actually do? Does it go on both sides? And what glue would I use to fix the Aquepanel to the stud (plus screws), would Gorilla be ok? Thank you.

I haven't used this panelling before, haven't done much tiing either. Shower panels look like the way forward if I can get some for above the bath. Does anyone supply custom panels? (probably not laminate). Thick enough to be rigid. For walls above long side and each end. Approx.160cm tall...

Hi All. I know what you are going to say, go and get the opinion of a professional struct eng. But this is a DIY forum so let's forget about the professionals for a moment. Trying to determine is the wall shaded yellow is structural? Some background. Bungalow, no second floor, so the...

Hi. I need some advice on a concrete slab that I’ve recently found under the floor boards in my daughters bedroom on the first floor. It’s in the corner of the room adjacent to the two exterior walls (and coldest walls). I’ve always had issues with damp patches on these walls and very much in...

We have a disused space in our kitchen where the original oil boiler used to be situated. Its essentially a cupboard space made up of 4 brickwork walls, 2 of those a shared with the 2 internal load bearing walls of the property. Above is a concrete pad, below ceiling level with the remaining...

Hey, we've been in our house a couple of years now, its not a new build, think it was built in 70,so maybe... anyways in the front room we've noticed where the window meets the wall in the bottom corner its cracked quite a bit and lets through a draught. There's also a hairline crack that runs...

Hi, I bought Reolink security cameras which I would like to fix outside my house. I everything will be straight forward, I will get the cable through the wall, and it's done. However, when my cameras arrived, I noticed that end of the cable is 20mm thick where ethernet cable connects. If I...

I have a Column radiator to fit to a porcelain tiled bathroom wall. The wall is breeze block covered (by solid bed of tile adhesive) with 12mm marmox board. The column radiator has four brackets with two fixing holes on each and come with screws and wall plugs. My questions are around the...

Parents had a gutter that was leaking for some time. That's now sorted, but it has left behind some unsightly white staining on the brickwork below. A scrubbing brush and soapy water has failed to shift it. Any ideas what it is exactly, and how best to clean it up? Photo attached.

Help would be appreciated - what do I need to do here?

First of all thanks everyone for helping with my self build, so much appreciated. Next stage complete the parapet wall design,roof timbers on for warm roof.My plan is to complete the top of the parapet wall either side,them fix the roof down. Need to keep the parapet wall to minimum height...

Hello, Hopefully a straightforward question (and hopefully I'm posting this in the right place), I have little to no DIY skills, but I'm working on it! We have an old Garage/Outbuilding that has been in a state of disrepair since long before we bought the house. We finally have a bit of time...

Hi, I'm building a workshop at the top of the garden..it's 6x3.5m. the slab has been poured but due to a mess up on my part it has a 0.5⁰ slope from the back to the front, putting the front around 50mm lower than the back. It will be a timber framed workshop on a single course of bricks (which...

Morning all,lintel help please,have asked the question before,but tomorrow I will be installing lintel 'hopefully' I understand the lintel needs to sit on full blocks if possible to support the 3900 IG lintel (flat roof single single ext) From my photos the external block work would be sitting...

Hi, I would like to fit a closed couple toilet to replace the rather bulky old style one. My main worry is that in the past I’ve had one fitted by a plumber and the cistern ended up about 30mm from the wall. At the moment the front of the 90deg pan connector is 160mm from the wall and the centre...

Hi, I’ve recently bought a new build house. I’m looking to change a standard double panel 600mm x 600mm radiator to a vertical radiator which is 1800mm x 480 mm. The vertical radiator weighs around 45-50kg before water. I think the current one is probably only 20kg before water. The current...

Hey, I have this small section of external wall (see attched image) that I'd like to tile over with more modern looking stone split face tiles. I'm after some advice as to how best to prepare the area. I was originally thinking I would chisel off the existing stone but found the existing stone...

Hi After getting rid of a huge bush INTL noticed the garden wall is tied into the house wall, and I always had damp in my kitchen in that corner. So I'm guessing that must be why. I've grinded it, and need to chip off the rest to get it relatively flush. I'm getting external wall insulation...

Looking to get an internal wall removed in my kitchen. This wall runs parallel to my joists. When i took off the frame I noticed that there is OSB under the plasterboard. Why is this? Kitchen cabinets on the other side of the wall so is this likely why? wall is definitely parallel to the...

Can anyone help me with this problem? I have 2 bedrooms that have a large vertical crack at the point where their joining wall meets the inner leaf exterior wall (circled in red). The walls are not plumb and it appears that the inner leaf wall is leaning into the cavity and pulling away from...