Intellisense Securit 800 keypad advice sought.

When I do 1234* it does same tone beep and whatever zone/PIR is being activated shows on the corresponding pad.

When I do 1234 to set alarm I it does a dual tone beep but does not seem to set the alarm ON?
The PIRs are getting activated though when I was doing this.
Would this prevent it from turning ON?
Plus what is the indication that the alarm is set ON?

Cheers
 
If your getting a two tone noise as in ne-na then it needs a reset by pressing #
Is the 24 yellow led off ? If not it won’t set as there is a tamper
The day light indicates set or unset
 
Yep sussed that I had to just press # when I had it that mode when I could see it trigger the PIR/ 4 zones.

I had the 24hr led off I think withn 1234#.
Not 100% how but it is off

It already triggered when I got there as tenant had removed the control box cover.

so it seems the alarm is constantly SET as DAY led is constant ON??

Yet I’m getting a 2 tone with 1234*.

Never seen anything so basic tbh.


Cheers
 
Last edited:
If you can’t suss a basic panel god help you with something more advanced .., by the way DAY light is off when set …it makes common sense …
 
Suss what?

Like I stated it’s very basic yet the info provided above to set a new code does not work.

I did to reset the NVM though.

As I stated 1234*91 does not enter mode to enter new pin. LEDs 1-4 do not illuminate.

I work on much more complex things than alarms mate.

Cheers
 
You must log in or register to reply here.
Back
Top