I would like my pyronix enforcer alarm to set my CCTV recording when I arm the alarm. What can I use on the alarm as an output and has anybody done this?
Pyronix enforcer alarm output when armed
- Thread starter rogerdygas
- Start date
Why ?
At the minute I get alerts that I don't need when I'm in, I would like to only get alerts when I'm out.
From what I gather I can use the pgm output bit I'm not too sure how to set this up in the alarm, or even if there are better options.
From what I gather I can use the pgm output bit I'm not too sure how to set this up in the alarm, or even if there are better options.
Ok ....so what is triggering the alerts ?
I will use an external pir and a couple of relays. When both the alarm is armed and the pir is triggered it'll close the circuit via relays and trigger and alarm.
Ok that will work if using external detectors , so set Ouput to any set...
I'm not sure on how to setup the whole pgm thing I can see the output on the alarm but I'm not sure how to setup in the menu, for it to output 12v when it is armed.
Go to outputs it will be pg1 and set to arm any ...exit to save , two options get a transistor relay that has a 12v + / 0v / trip connection ...wire the pg1 to trip and the other two to + and - as the output is limited to around 250ma
- Joined
- 4 Dec 2019
- Messages
- 4
- Reaction score
- 0
- Country
If you can help. I am looking to do something similar but can't find an output type "arm any" i can find a "Final set any" softwear is V09.53d
That’s correct final set any
- Joined
- 4 Dec 2019
- Messages
- 4
- Reaction score
- 0
- Country
Thank you. Very helpful
- Joined
- 4 Dec 2019
- Messages
- 4
- Reaction score
- 0
- Country
Just Got round to trying it and i can not get 12v output. So in "Endstation Outputs" i have set PGM to 22(Final set any). Wired the output to PGM1 and COM on the next terminal block Z33, COM,+12V,Z34
But i am not getting 12v when set or unset.
Can you help as i am stuck
Thanks
Last edited:
- Joined
- 4 Dec 2019
- Messages
- 4
- Reaction score
- 0
- Country
Gave up on the PGM output and installed an OEM8R8T. I bit overkill but it works.
- Joined
- 27 Oct 2023
- Messages
- 9
- Reaction score
- 1
- Country
Hi all, is it possible to use the PGM output to open and close my electric garage door from my mobile app?
Yes…