Pyronix hyrbid alarm

Not only that but also offers a fully supervised loop, if u use 4 wire and get a short on the alarm pair you wouldnt know about it until u did a walk test or got broken into and the alarm didnt go off
 
Bigsosij said:
Not only that but also offers a fully supervised loop, if u use 4 wire and get a short on the alarm pair you wouldnt know about it until u did a walk test or got broken into and the alarm didnt go off
Click to expand...
Fair enough thanks
 
Bigsosij said:
Not only that but also offers a fully supervised loop, if u use 4 wire and get a short on the alarm pair you wouldnt know about it until u did a walk test or got broken into and the alarm didnt go off
Click to expand...
Quick question,

I have noticed that one PIR is connected to another PIR then one wired goes to the panel, can I replicate this on the pyronix ? And how do I go about this, appreciate its not the best way but I can’t run another wire.
 
Depends on what cable is used ….eg 4 core 1 detector , 6 core 2 detectors , 8 core 3 ….
 
sparkymarka said:
Depends on what cable is used ….eg 4 core 1 detector , 6 core 2 detectors , 8 core 3 …
Click to expand...

Theres 6 cores going from PIR1 to PIR2 and then 6 cores going to panel.

I was going to use 4 core with the resistors in the PIRs
 
You must log in or register to reply here.
Back
Top