Washing machine NTC sensor resistance

Just to update, I sourced and fitted a new triac yet still no warm water after 10 minutes run on a 60° wash cycle.

There appears to be four relays on the board but no idea each how pin on the relays connects and it would mean removing them to test.

I suppose an easy option is to pour some hot water into the drum before loading each wash.


full
 
well done at last you found the relay the triac is for the motor the relay you want is the one next to the heater plug
 
Have removed and check the two relays nearest the heater wire terminals and both are good.

Seems its a chip fault on the pcb that's stopping the heater from working.
 
Update!

I retested all the wires to/from the ntc and heater element and all are good. I've replaced the triac and tested the relays and all are good.

I fitted a replacement water level sensor, the seller advising which contacts should be open/closed for both pressure/non-pressure positions and seems well there.

Unless one of the brown wire multi-plugs on the controller pcb is plugged into the wrong socket (before it left the factory), then I'd say its the pcb that has the fault preventing the heater working. I not going to swap multi-plugs around for fear of damaging the pcb.
 
You must log in or register to reply here.
Back
Top