shower

Hi The shower head holder for this rail/riser is broken. I want to see if I can buy a replacement insert or complete holder, rather than replace the whole rail, which would be a lot more effort. Does anyone have any idea what brand or model this might be? The shower head has been replaced and I...

I'm in the need of some help please?.. I would really appreciate it. So the electirc mira shower I have turns on and then after around a minute it turns off while beeping and the button light flashing. When I try and press the button on it will not start. It will only start again once the...

Greetings, I’d really appreciate any advice on this problem, I’ve done some googling but ended up even more confused. my problem is 2-fold: 1. the middle tap (mixer) doesn’t provide 100% cold water (always luke warm) even when turned all the way clockwise. 2. the top tap (shower...

Hi All, Just finishing my wet room. I have a linear drain in the end embedded and secured levelled into the concrete floor. I am now ready to do the wet room slope pan. I have placed two pieces of strip wood on each side and raised them accordingly to my slope measurements. I will use these...

Hi, so recently my electric shower started running lukewarm at settings where it would usually run nice and hot. To get it to run hot, it has to be turned to higher settings, but with that, the water pressure drops significantly. I’ve also noticed that the half power light is no longer lit...

I've had a Salamander negative head pump installed in the airing cupboard, just above the HWC. The HWC has has an Essex flange with the required anti-gravity loop installed and the cold water tank is about a metre above the pump in the loft. The outputs from the pump go back up into the loft and...

I have a Triton HP Combi shower in my bathroom. It's probably 20 years old. Recently it has been acting a bit strange - if I turn the water temperature all the way down, the water is still a bit warm. It used to be ice cold. Maybe it doesn't matter...I'm not one for taking freezing cold...

Hi there, very new to the forum. Seen some very helpful information floating around on here, however I think I need more specific help if possible. Dropped some pictures below of exactly where the water seems to be coming from. The nut which tightens to bar part of the shower, this is the...

Hi, There's a mouldy smell in my shower room, and I think it may be coming from the extractor fan. I removed the cover and cleaned around the motor and blades, which were pretty black, but I couldn't reach into the ducting. First, I'd like to know if mould in extractor fan ducting is a thing...

Please help me its doing my head in. Everyone just assumes HOT overheat trip out with thermo BUT NOT It trips out when set JUST just running COLD approx 5 minutes every time Tested it all afternoon running JUST COLD trying to flush (hopefully Woefully) and it still stops running approx 5 mins...

Hi everyone I have a problem where the kids were messing around in the bathroom and our mixer has now come off. I've added some pics could someone please help as to putting it back on or replacing? Many thanks

Hi Can someone please offer advice on which water pump to pick? It'll be for the hotwater to the bath and a downstairs shower room, the cold is on mains and the upstairs shower is electric. We have a hot water cylinder at ground level (about 5m away from the original wall of the house) which...

Hi all, I've a Shower mixer to help a handyman to install, The shower is a Maina: https://www.diy.com/departments/maina-chrome-effect-mixer-shower/1618581_BQ.prd It seems like a poor product, but I've got it and would like to give it a try. It looks like I need to replace the z connectors with...

After replacing the boiler to a combi from a system the shower mixer no longer works correctly. I assume this is due to now having mains pressure from the hot side but essentially the mixer is always ON. Occasionally the internals seem to move enough to provide an OFF setting but it does not...

Hi Come someone please help. We recently moved into a old house with 2 X 80s shower room upstairs and a newish shower room downstairs, with a Thermostatic shower that's always been on the hot side and control valve not even turning a quarter of the way. This week we started combining the 2...

Hi, apologies if this is the wrong section. I'm in a bit of a pickle, our shower has started leaking, a lot, and it looks like there had been a small leak for a while that soaked through the grout (or round it) and destroyed the plasterboard behind it, this in turn allowed movement which made...

Hi all, I'm discussing with a plumber whether it's possible to replace a bathtub with a shower and storage space but am not doing a very good job of asking the right questions to work out if it's feasible from a space perspective as I don't have the technical terminology. What I'd like to...

Good morning all !! First post and hopping this is the right place for it !! I moved into a house just before Xmas and the en-suite has a shower with bifold doors .... the bottom runner was already out and now the top has come away .... I’ve looked online but can’t seem to find any that...

I have got bldg reg approval for utility extension including W.C. However I would like to create a small 3 piece bathroom (shower, toilet, sink)instead of just a W.C. which would require it to be sited in a different corner than on the current plans. Do I need to resubmit for approval before...

Hi all, Thanks for your thoughts on this: I've used cement board and then BAL tanked for shower walls before. I've got someone coming in to redo our bathroom who is suggesting he'd use Aquaboard: https://www.siniat.co.uk/en/products-and-systems/products/internal-boards/10-aqua-board. I've...