New Boiler installation

Status
Not open for further replies.
Steelmasons said:
So 10 minutes to fit sensor (drill plug screw) , run cable , wire sensor , connect cable inside....
Yea right..:)
How long to set up?...oh , and how long to get tools on/off van??
Click to expand...
He only got a drill, roll of wire, some screwdrivers and electrical wire cutter thats it and loads of wire clips and used my hammer.
It was twin wires that connect through a hole in the boiler on to the clearly marked weather compensation port...thats it
 
10 minutes is bollacks..;)...no need to BS..
I would have taken a tad longer with the use of conduit.
 
BS..boiler front case off , cable secured within boiler and connected to control board , setting up of components.....
I know exactly how long it takes and it ain't 10 minutes trust me...
 
How long to fill out the relevant paperwork FFS????:ROFLMAO::ROFLMAO:
Apparently the "installer" calls you @ 5.30 pm to ask if you would like him to fit weather comp and low and behold it's all done and dusted before it gets dark...
 
Steelmasons said:
How long to fill out the relevant paperwork FFS????:ROFLMAO::ROFLMAO:
Click to expand...
What paper work, he placed sticker and signed and dated it and a tick on the book
Thats it
The sticker is from ideal lol...
Does he have to commission the boiler again?
 
[GALLERY=media, 99438]IMG_4487 by BigRedBus posted 15 Mar 2017 at 7:44 PM[/GALLERY]
Instructions if it helps anyone
 
There is no "installer" is there??
Post a snap shot of the benchmark..
 
Now we're getting somewhere..
FGA results upon commissioning????:):):)....yea right...:ROFLMAO::ROFLMAO::ROFLMAO:
 
:LOL:[GALLERY=media, 99439]IMG_4489 by BigRedBus posted 15 Mar 2017 at 7:53 PM[/GALLERY][GALLERY=media, 99440]IMG_4491 by BigRedBus posted 15 Mar 2017 at 7:53 PM[/GALLERY]
[GALLERY=media, 99441]IMG_4492 by BigRedBus posted 15 Mar 2017 at 7:53 PM[/GALLERY]
Happy
 
Status
Not open for further replies.
Back
Top